VIDEOS / TUTORIALS

In this video we are looking at how Ansys Discovery is used for fluid flow analysis (CFD). We look at how it can be used to aid designers in better understanding there products and allowing them to optimise designs. We look at two examples one an internal HVAC simulation and the second an external fluid flow simulating a vehicle in a wind tunnel. Any questions regarding the video or software please get in touch - www.origin-eng.co.uk

In this video we look at how Ansys Discovery is used for model Exploration. We harness the speed and power of Discovery to quickly run through multiple simulations CFD, FEA and Topology optimisation while making design changes to see what effect they have on the efficacy of our designs. To find out more go to www.orgin-eng.co.uk

In this video we look at how Ansys Discovery can be used for FEA/Structural simulation. We look at how the explore mode can be used for rapid design exploration and also how you can mesh your parts in the refine mode for validation. If you have any questions feel free to comment or contact us at www.origin-eng.co.uk

In this video we look at thermal Analysis in Ansys Discovery. We look at a simple thermal analysis on an electronics board. Secondly we look at CHT or fluid, solid heat transfer to show the effect of a cooling channel on a thermal analysis. If you have any questions on the setup or software please comment below.

In this webinar showcasing Ansys Discovery, we start off discussing the opportunities and challenges with using #simulation earlier in the design process. Through a demonstration of a drone, we look at #finiteelementanalysis, #cfd #thermalanalyis and #optimisation using #ansys discovery. For more information contact us at www.origin-eng.co.uk

Short video showing fluid flow over an F1 Car. The difference here is this is being run in real-time and also over a faceted or STL model. Discovery has the ability to run simulations on faceted data. To find out more - www.origin-eng.co.uk

In this video we look at Factor of Safety within Ansys Discovery and how it can be used to better understand your products and help with design.

In this video we look at topology optimisation in Ansys Discovery and how this can be used to guide and better your product design. We look at how you can add different manufacturing constraints as well as multiple load cases to optimise a part for weight reduction of different manufacturing methods.

Using Ansys Discovery, we can quickly perform FEA simulations to look at the factor of safety of models. We can switch between meshless and traditional mesh based approaches catering for all skill levels.